A question can only have one accepted answer. Are you sure you want to replace the current answer with this one?
You previously marked this answer as accepted. Are you sure you want to unaccept it?
I keep getting this error while assigning a droplet to a Floating IP. The Floating IP used to point to the droplet, and when I try to reassign it I get “Data error processing assign_ip action”.
Any thoughts?
Hi, when i add domains to droplet it showing error that. To add more than ** domains to your account, you can submit a request ticket. Request an Increase support team people saying there is some code change. we are waiting for engineer update. Recently i read in community questions that there is no limit in no of domains added to droplet. but now they imposed limit on no of domains per account. they given provision to request more domains form. i submitted the form but not increased wait for the update from digitalocean team.
I took a snapshot of my Ubuntu after which I destroyed it. Now I'm trying to restore it and I'm having problems with networking. I only have the loopback lo at 127.0.0.1. In the previous droplet I had eth0 defined in /etc/network/interfaces.d/00-default.cfg. Now I got a new public IP and most likely a new subnet IP. Before it was 198.199.125.73. Now I don't know what it is nor how to check it. When I do: systemctl restart networking it fails, and journalctl -xe contains a line with "Failed to start Raise network interfaces." How can I recover and get the net working?
Hi, I got this email " We have detected what appears to be malware content originating from one or more of your Droplets. Details can be found in the Abuse Complaint tickets on your account. To prevent anyone from being exposed, we have disabled the networking interface on the Droplet or Droplets involved. " The problem is someone hack my website and upload phishing content, i am unable to open connection using cyberduct or filezilla, kindly active my droplet so i can delete the file. [DigitalOcean] Ticket #546248 Also check this[Ticket #522101] Fwd: RE: Bank of America Phishing Detected Case # EID-2017-8-64103
I am using a Floating IP (```45.55.x.x```) as a secondary IP for a droplet (which has a default IP, ```157.230.x.x```). When I look at the network interfaces on the droplet using ```ip -a```, I see the following: ``` momo@droplet:~$ ip a | head -n 20 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000 link/ether [...] brd ff:ff:ff:ff:ff:ff inet 157.230.x.x/20 brd 157.230.x.x scope global eth0 valid_lft forever preferred_lft forever inet 10.10.0.5/16 brd 10.10.255.255 scope global eth0 valid_lft forever preferred_lft forever inet6 [...]/64 scope link valid_lft forever preferred_lft forever ``` After some testing using nginx, I can see that requests going through the floating IP are mapped to the second inet in the eth0 interface, ```10.10.0.5```. My question is, how is that local IP address determined and mapped from the external IP (```45.55.x.x```)?