Is there any tutorial on how to install and run backups using bacula on FreeBSD?

August 12, 2016 1.2k

FreeBSD Backups

By:

vincent1417

I used other tutorials but it does not work. I was hoping if Digital Ocean plans on making a tutorial about bacula on FreeBSD Thank you! :)

Log In to Comment

1 Answer

Elizine August 15, 2016

Please refer this link - https://project.altservice.com/issues/637

Have another answer? Share your knowledge.

Related

question

FreeBSD Backups - can enable after creation, but not during. Bug or a feature?

While creating a FreeBSD 10.3 zfs droplet, during creation it says backups are not available with this configuration. After creation, however, it seems I can enable them. A backup hasn't run yet, I'm guessing it will fail when it tries? Is this a bug, or are backups now enabled for FreeBSD + zfs and the creation page hasn't been updated yet?
question

droplet created, but not serving webpages ...

I have created a FreeBSD droplet bearing IP address; 104.236.3.64 and the droplet instance is refusing to serve webpages. What might be wrong, and how could I remedy the issue?
question

Is it possible to configure bacula on debian and what version?

I wanted to use Debian for the installation of bacula, for my summer internship but I am a beginner on this domain.Alors I ask for help and thank you
question

Kernel Panic Issue - not syncing VFS, unable to mount root fs

I suddenly got a notification of my CPU usage being high, and when I check my website - it was down. And, then tried to log in to FTP to deactivate WordPress plugins to see if it's an issue with WordPress (but couldn't access FTP/SSH as well) Then I went to the dashboard and tried to access the console of Digital Ocean, and it displayed the following error in the image below: http://prntscr.com/o1z7au The last DO support response was to go to the recovery mode then: -check filesystem -mount disk image (or filesystem) (is it the same thing?) (Refer to this: https://www.digitalocean.com/docs/droplets/resources/recovery-iso/) Then change the recovery mode to HDD and then power back on the droplet. Maybe I misunderstood the official support response? Or did I miss something else? I also tried restoring the droplet backup - that didn't work either. Do I have to fix the issue before trying to restore the backup? I'm kinda in a panic mode - so please help me with a detailed response. I don't know how the hell did this problem occur in the first place.